I just created a laminated Micarta handle with black and natural linen micarta. I also used loveless rivets to fasten the scales because I thought that the two tone brass and stainless rivets would look good with the yellow-ish Micarta.
Nov 7, 2016
This one is made with CPM154 hardened to 59hr. The spine is 1/4 inch thick and the bevel is flat ground and I tapered the tang to lower the weight and move the balance forward a bit.
Most Commented Posts
Completed Warncliffe Brute Utility Knife - Wahmaster on First attempt at a hollow grind. […] my earlier post I showed my first attempt at ...
Jeff Soule on Profile, Heat Treat, Bevel As it turns out grinding is not too bad after ...